Hey, just figured I'd mention there's something of a graphical glitch when you use the CH-X25 RM scope. It's the scope that looks like the top of an XM8 assault rifle/SMG/LMG/blender. In the main customization window when you're editing it, it looks GREAT.

But if your character is holding it on the MAIN page, the long arms don't always reach to the top of the barrel, and it's even worst on the HAR where it's TOTALLY not attaching to the top of the barrel. I use the Elite X3-455 barrel on both, and I run Medium on most my settings since my PC isn't great. But you'd think the character viewer part would look better than it does.

Anyways, just something that might be a problem with LoD not rendering right in that close-mode, since everything else renders fine.


PS Edit: Figured we could use a thread to post ALL the graphical glitches. So yeah, see a graphical glitch, post about it here.

It has an issue with the CR as well - it's set so low that it visibly clips into the top rail.

New graphical glitch spotted. ALL Muzzles do not line up correctly with the V2 X200 Mod Light Pistol Barrel.

What does that mean? Well, all the muzzles are about 1/4 barrel up from where the barrel technically starts on the V2 X200 Mod pistol barrel.

So if your barrel is mounted.... it lines up like this.

(====)----______|
Muzzle part: Barrel part.

Basically, either the barrel's barrel needs to rise up about 1/4 an inch, or the muzzles need to move down about 1/4 of an inch.

And this is easy to see in the Customization window. Go check it.

Can I get some screenshots?

Also, that pistol barrel mod not lining up with the muzzles is a known issue. It is a very low priority though.